[Updated 2022]Save even more with a CCNP 350-401 ENCOR dumps
Save even more with a CCNP 350-401 ENCOR dumps

First, you’ll need to prepare for the CCNP 350-401 ENCOR exam for $400, which is not a small fee. If you can use the 350-401 dumps to succeed the first time you take the 350-401 ENCOR exam, then why not choose! This can be a huge saving!

Here you can select the newly updated CCNP 350-401 ENCOR dumps https://www.lead4pass.com/350-401.html, to help you successfully pass Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) on your first attempt at an exam.

Lead4Pass 350-401 dumps have real-world test-room success with a high score of 98.7% to help you pass the Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) exam with ease.
The 726 newly updated 350-401 dumps are verified by a team of experienced experts to ensure you take the Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) exam without fail.

Latest Cisco 350-401 dumps exam questions Free sharing

Updated 2022.6


Refer to the exhibit. An engineer must create a configuration that prevents R3from receiving the LSA about Which configuration set achieves this goal? [Missing the exhibit]

A. On R3 ip access-list standard R4_L0 deny host permit any
router ospf 200
distribute-list R4_L0 in

B. On R3 ip prefix-list INTO-AREA1 seq 5 deny ip prefix-list INTO-AREA1 seq 10 permit le 32
router ospf 200
area 1 filter-list prefix INTO-AREA 1 in

C. On R1 ip prefix-list INTO-AREA1 seq 5 deny ip prefix-list INTO-AREA 1 seq 10 permit le 32
router ospf 200
area 1 filter-list prefix IN TO-AREA1 in

D. On R1 ip prefix-list INTO-AREA1 seq 5 deny ip prefix-list INTO-AREA1 seq 10 permit le 32
router ospf 200
area 1 filter-list prefix INTO-AREA1 out


Which AP mode allows an engineer to scan configured channels for rogue access points?

A. sniffer
B. monitor
C. bridge
D. local


Refer to the exhibit.

The EtherChannel between SW2 and SW3 is not operational which action resolves this issue?

A. Configure the channel-group mode on SW2 Gi0/0 and Gi0/1 to on.
B. Configure the channel-group mode on SW3 Gi0/0 and Gi0/1 to active.
C. Configure the mode on SW2 Gi0/0 to the trunk.
D. Configure the mode on SW2 Gi0/1 to access.


Refer to the exhibit.

A network engineer is configuring OSPF between router R1 and router R2. The engineer must ensure that a DR/BDR election does not occur on the Gigabit Ethernet interfaces in area 0. Which configuration set accomplishes this goal?

A. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network point-to-point R2(config-if)interface Gi0/0
R2(config-if)ip ospf network point-to-point

B. R1(config-if)interface Gi0/0 R1(config-if)ip ospf network broadcast
R2(config-if)interface Gi0/0
R2(config-if)ip ospf network broadcast

C. R1(config-if)interface Gi0/0 R1(config-if)ip ospf database-filter all out
R2(config-if)interface Gi0/0
R2(config-if)ip ospf database-filter all out

D. R1(config-if)interface Gi0/0 R1(config-if)ip ospf priority 1
R2(config-if)interface Gi0/0
R2(config-if)ip ospf priority 1


How does EIGRP differ from OSPF?

A. EIGRP is more prone to routing loops than OSPF
B. EIGRP has a full map of the topology, and OSPF only knows directly connected neighbors
C. EIGRP supports equal or unequal path cost, and OSPF supports only equal path cost.
D. EIGRP uses more CPU and memory than OSPF


Get more 350-401 exam questions and verify the answers above

You can first detect lead4Pass 350-401 free dumps

2022 350-401 [Q1]:

Which statements are used for error handling in Python?

A. try/catch
B. try/except
C. block/rescue
D. catch/release

Correct Answer: B

The words “try” and “except” are Python keywords and are used to catch exceptions.
For example:
print 1/0
except ZeroDivisionError:
print \’ Error! We cannot divide by zero!!!\’

2022 350-401 [Q2]:

What is the function of a fabric border node in a Cisco SD-Access environment?

A. To collect traffic flow information toward external networks
B. To connect the Cisco SD-Access fabric to another fabric or external Layer 3 networks
C. To attach and register clients to the fabric
D. To handle an ordered list of IP addresses and locations for endpoints in the fabric.

Correct Answer: B

2022 350-401 [Q3]:

What are two benefits of virtualizing the server with the use of VMs in the data center environment? (Choose two.)

A. Increased security
B. reduced rack space, power, and cooling requirements
C. reduced IP and MAC address requirements

D. speedy deployment
E. smaller Layer 2 domain

Correct Answer: BD

Server virtualization and the use of virtual machines are profoundly changing data center dynamics. Most organizations are struggling with the cost and complexity of hosting multiple physical servers in their data centers. The expansion of the data center, a result of both scale-out server architectures and traditional “one application, one server” sprawl, has created problems in housing, powering, and cooling large numbers of underutilized servers. In addition, IT organizations continue to deal with the traditional cost and operational challenges of matching server resources to organizational needs that seem fickle and ever-changing. Virtual machines can significantly mitigate many of these challenges by enabling multiple application and operating system environments to be hosted on a single physical server while
maintaining complete isolation between the guest operating systems and their respective applications. Hence, server virtualization facilitates server consolidation by enabling organizations to exchange a number of underutilized servers for a single highly utilized server running multiple virtual machines. By consolidating multiple physical servers, organizations can gain several benefits:
Underutilized servers can be retired or redeployed.
Rack space can be reclaimed.
Power and cooling loads can be reduced.
New virtual servers can be rapidly deployed.
CapEx (higher utilization means fewer servers need to be purchased) and OpEx (few servers means a simpler environment and lower maintenance costs) can be reduced.

Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-centervirtualization/net_implementation_white_paper0900aecd806a9c05.html

2022 350-401 [Q4]:

Which IP SLA operation requires the IP SLA responder to be configured on the remote end?

A. ICMP echo
B. UDP jitter
C. CMP jitter
D. TCP connect

Correct Answer: B

Cisco IOS IP SLA Responder is a Cisco IOS Software component whose functionality is to respond to Cisco IOS IP SLA request packets. The IP SLA source sends control packets before the operation starts to establish a connection to the responder. Once the control packet is acknowledged, test packets are sent to the responder. The responder inserts a time-stamp when it receives a packet and factors out the destination processing time and adds timestamps to the sent packets. This feature allows the calculation of unidirectional packet loss, latency, and jitter measurements with the kind of accuracy that is not possible with ping or another dedicated probe testing.
The IP SLAs responder is a component embedded in the destination Cisco device that allows the system to anticipate and respond to IP SLAs request packets. The responder provides accurate measurements without the need for dedicated probes.
UDP Jitter measures the delay, delay variation(jitter), corruption, and misordering packet loss by generating periodic UDP traffic. This operation always requires an IP SLA responder.

Reference: https://www.ciscolive.com/c/dam/r/ciscolive/us/docs/2017/pdf/BRKNMS-3043.pdf https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/46sg/configuration/guide/Wrapper-46SG/swipsla.pdf

2022 350-401 [Q5]:

Which statement about a fabric access point is true?

A. It is in local mode and must be connected directly to the fabric border node.
B. It is in FlexConnect mode and must be connected directly to the fabric border node.
C. It is in local mode and must connect directly to the fabric edge switch.
D. It is in FlexConnect mode and must be connected directly to the fabric edge switch.

Correct Answer: C

Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.

Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

2022 350-401 [Q6]:

Which network devices secure API platforms?

A. next-generation intrusion detection systems
B. Layer 3 transit network devices
C. content switches
D. web application firewalls

Correct Answer: A

2022 350-401 [Q7]:

Which solution do laaS service providers use to extend a Layer 2 segment across a Layer 3 network?


Correct Answer: C

2022 350-401 [Q8]:

What is the function of the fabric control plane node In a Cisco SD-Access deployment?

A. It is responsible for policy application and network segmentation in the fabric.
B. It performs traffic encapsulation and security profiles enforcement in the fabric.
C. It holds a comprehensive database that tracks endpoints and networks in the fabric.
D. It provides Integration with legacy nonfabric-enabled environments.

Correct Answer: C

Fabric control plane node (C): One or more network elements that implement the LISP Map-Server (MS) and Map-Resolver (MR) functionality. The control plane node`s host tracking database keeps track of all endpoints in a fabric site and associates the endpoints to fabric nodes in what is known as an EID-to- RLOC binding in LISP.

Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/cisco-sda-macro-segmentation-deploy-guide.html

2022 350-401 [Q9]:

Which protocol is used to encrypt control plane traffic between SD-WAN controllers and SDWAN endpoints?

B. IPsec

Correct Answer: A

2022 350-401 [Q10]:

Which two statements about IP SLA are true? (Choose two)

A. It uses NetFlow for passive traffic monitoring
B. It can measure MOS
C. The IP SLA responder is a component in the source Cisco device
D. It is Layer 2 transport-independent correct
E. It uses active traffic monitoring correct
F. SNMP access is not supported

Correct Answer: DE

IP SLAs allows Cisco customers to analyze IP service levels for IP applications and services, increase productivity, lower operational costs, and reduce the frequency of network outages. IP SLAs use active traffic monitoring the generation of traffic in a continuous, reliable, and predictable manner or measuring network performance. Being Layer-2 transport-independent, IP SLAs can be configured end-to-end over disparate networks to best reflect the metrics that an end-user is likely to experience. Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipsla/configuration/15-mt/sla-15- mt-book/ sla_overview.html

2022 350-401 [Q11]:

Drag and drop the characteristics from the left onto the infrastructure deployment models on the right.
Select and Place:

Correct Answer:

2022 350-401 [Q12]:

What is used to measure the total output energy of a Wi-Fi device?

A. dBi
C. mW

D. dBm

Correct Answer: C

Output power is measured in mW (milliwatts). answer \’dBi\’ milliwatt is equal to one thousandth (10-3) of a watt.

2022 350-401 [Q13]:

How does the RIB differ from the FIB?

A. The RIB is used to create network topologies and routing tables. The FIB is a list of routes to particular network destinations.

B. The FIB includes many routes and a single destination. The RIB is the best route to a single destination.

C. The RIB includes many routes to the same destination prefix. The FIB contains only the best route

D. The FIB maintains network topologies and routing tables. The RIB is a list of routes to particular network destinations.

Correct Answer: A


lead4pass 350-401 free dumps online download:https://drive.google.com/file/d/1tguhWg1Nll916gOwXjk-aX-vhSDxkRAk/view?usp=sharing

[Updated 2022.6] [Google Drive] Cisco 350-401 dumps exam questions online download:https://drive.google.com/file/d/1CzUD7IShCoh1JNUYek2Q2REVIzJprjMs/

The lead4pass 350-401 dumps are really effective in Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) exam prep material.
Use the 350-401 dumps https://www.lead4pass.com/350-401.html to ensure you pass the Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) exam with ease.